LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Supplemental Restraint System (3 Of 3) (Except Hybrid)) >> Removal And Installation >> Seat Position Sensor >> Removal

Seat Position Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.
  1. NOTE: RH seat shown, LH seat similar.

    1. Remove the screw.

      Torque: 8 lb.in (0.9 Nm)

    2. Disconnect the electrical connector.
    3. Remove the seat position sensor.

GFD485525Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals