LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Supplemental Restraint System (3 Of 3) (Except Hybrid)) >> Removal And Installation >> Restraints Control Module (RCM) >> Installation

Restraints Control Module (RCM): Installation

WARNING: This page is about a different variant/trim than selected.
  1. To install, reverse the removal procedure.
  2. If the SRS was depowered, repower the SRS.

    Do not  prove out the SRS at this time. Refer to: Supplemental Restraint System (SRS) Depowering and Repowering .

  3. NOTE: This step is only necessary when installing a new component.

    When installing a new RCM, Programmable Module Installation (PMI) is required. Refer to the diagnostic scan tool instructions to carry out Programmable Module Installation (PMI).

  4. NOTE: This step is only necessary when installing a new component.

    Using a diagnostic scan tool, carry out the ABS module initialization following the on-screen instruction.

    • If a new RCM was installed, prove out the SRS as follows: Turn the ignition from ON to OFF. Wait 10 seconds, then turn the ignition back to ON and monitor the airbag warning indicator with the airbag modules installed. The airbag warning indicator illuminates continuously for approximately 6 seconds and then turns off. If a SRS fault is present, the airbag warning indicator either fails to light, remains lit continuously or flashes.

    • The flashing might not occur until approximately 30 seconds after the ignition has been turned from OFF to ON. This is the time required for the RCM to complete the testing of the SRS. If the airbag warning indicator is inoperative and a SRS fault exists, a chime sounds in a pattern of 5 sets of 5 beeps. If this occurs, diagnose and repair the airbag warning indicator and any SRS faults.

scientia non olet · About LEMON Manuals