LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Supplemental Restraint System (3 Of 3) (Except Hybrid)) >> Removal And Installation >> Clockspring >> Installation

Removal And Installation: Clockspring: Installation

WARNING: This page is about a different variant/trim than selected.
  1. NOTE: If installing a new clockspring, do not remove the clockspring anti-rotation key until the steering wheel is installed. If the anti-rotation key has been removed before installing the steering wheel, the clockspring must be centered. Failure to follow this instruction may result in component damage and/or system failure.

    To install, reverse the removal procedure.

  2. NOTE: This step is only necessary if adjustment or centralizing is required.

    Adjust the clockspring. Refer to: Clockspring Adjustment .

  3. If the SRS was depowered, repower the SRS. Refer to: Supplemental Restraint System (SRS) Depowering and Repowering .
scientia non olet · About LEMON Manuals