Pinpoint Test A : U0146:00: Notes
WARNING: This page is about a different variant/trim than selected.
Diagnostic Overview
Normal Operation and Fault Conditions
The RCM uses information contained in messages from the GWM sent on the High Speed Controller Area Network 2 (HS2-CAN).
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0146:00 | Lost Communication with Gateway "A": No Sub Type Information | This DTC sets if the RCM does not receive an expected message from the GWM. |
Possible Sources
- Network traffic
- GWM
- RCM