LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Rear Suspension (Except Hybrid)) >> Removal And Installation >> Wheel Studs >> Installation

Wheel Studs: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Press the wheel stud into the wheel bearing and wheel hub flange until fully seated. Use the General Equipment: Hydraulic Press
    GFD478938Courtesy of FORD MOTOR COMPANY
  2. Install the wheel bearing and wheel hub. Refer to: Wheel Bearing and Wheel Hub - FWD . Refer to: Wheel Bearing and Wheel Hub - AWD .
scientia non olet · About LEMON Manuals