LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine System - General Information (Except Hybrid)) >> Diagnosis And Testing >> Engine >> Oil Pressure Test

Oil Pressure Test

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and remove the oil pressure switch (refer to the appropriate service information OIL PRESSURE SWITCH - 1.5L / OIL PRESSURE SWITCH - 2.0LOIL PRESSURE SWITCH - 2.5L ) or EOP sensor (refer to the appropriate service information ENGINE OIL PRESSURE (EOP) SENSOR - 2.0L ).
  2. Connect a commercially available oil pressure gauge to the oil pressure sender oil galley port.
  3. Run the engine until normal operating temperature is reached.
  4. Run the engine at the specified rpm and record the gauge reading.
  5. The oil pressure should be within specifications, refer to the specification chart in the appropriate service information OIL PRESSURE - 1.5L / OIL PRESSURE - 2.0L / OIL PRESSURE - 2.5L .
  6. If the pressure is not within specification, check the following possible sources:

    • Insufficient oil

    • Oil leakage

    • Worn or damaged oil pump

    • Oil pump screen cover and tube

    • Excessive main bearing clearance

    • Excessive connecting rod bearing clearance

    • Chain tensioner leak

  7. Remove the commercially available oil pressure gauge.
  8. Install and connect the oil pressure switch (refer to the service information OIL PRESSURE SWITCH - 1.5L / OIL PRESSURE SWITCH - 2.0LOIL PRESSURE SWITCH - 2.5L ) or EOP sensor (refer to the appropriate service information ENGINE OIL PRESSURE (EOP) SENSOR - 2.0L ).
scientia non olet · About LEMON Manuals