Pinpoint Test AZ : The Ignition-Engine On Warning Chime Is Inoperative

AZ1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Unbuckle the driver safety belt.
- Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?

Yes GO to AZ2

No Refer to IPC Guided Routine Testing .

AZ2 CHECK THE DOOR AJAR INDICATION
- Open the driver door.
- Observe the door ajar RTT warning indicator.
Does the door ajar RTT warning indicator turn on with the driver door ajar?

Yes GO to AZ3

No GO to Pinpoint Test AD

AZ3 CHECK THE PRNDL OPERATION
- Shift the transmission range selector through the ranges while observing the PRNDL indication.
Does the PRNDL indication match the selected transmission range?

Yes GO to AZ4

No GO to Pinpoint Test O

AZ4 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to DTC Chart: IPC .

No GO to AZ5

AZ5 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).

Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes	REFER to: Communications Network - 2.0L Duratec - Hybrid (103kW/140PS) (UA) .

No	Refer to ENGINE CONTROLS - INTRODUCTION (HYBRID) . DIAGNOSE all SOBDMC Diagnostic Trouble Codes (DTCs). Refer to ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (HYBRID) .