Pinpoint Test B : An Individual Front Fog Lamp Is Inoperative: Notes
WARNING: This page is about a different car, the 2019 Ford SSV Plug-in Hybrid, 2019 Ford Police Responder Hybrid, and 2019 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
An Individual Front Fog Lamp Is Inoperative
Normal Operation and Fault Conditions
REFER to: Exterior Lighting - Overview .
REFER to: Exterior Lighting - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B1147:11 | Left Front Fog Lamps: Circuit Short To Ground | A continuous memory and on-demand DTC that sets when the BCM detects a short to ground from the left fog lamp output circuit. |
| B1147:15 | Left Front Fog Lamps: Circuit Short To Battery or Open | A continuous memory and on-demand DTC that sets when the BCM detects an open or short to voltage from the left fog lamp output circuit. |
| B1148:11 | Right Front Fog Lamps: Circuit Short To Ground | A continuous memory and on-demand DTC that sets when the BCM detects a short to ground from the right fog lamp output circuit. |
| B1148:15 | Right Front Fog Lamps: Circuit Short To Battery or Open | A continuous memory and on-demand DTC that sets when the BCM detects an open or short to voltage from the right fog lamp output circuit. |
| U1000:00 | Solid State Driver Protection Actived -Driver Disabled: No Sub Type Information | This DTC sets when the BCM has temporarily shut down the output driver. The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected, the Diagnostic Trouble Codes (DTCs) have been cleared and a successful self-test is run. For additional information on BCM Field Effect Transistor (FET) protection, REFER to: Module Controlled Functions - System Operation and Component Description . |
| U3000:49 | Control Module: Internal Electronic Failure | This DTC sets when the BCM has permanently shut down the output driver. The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. CORRECT the cause of the excessive current draw before installing a new BCM. For additional information on BCM Field Effect Transistor (FET) protection, REFER to: Module Controlled Functions - System Operation and Component Description . |
Possible Sources
- Bulb
- Wiring, terminals or connectors
- BCM
Visual Inspection and Diagnostic Pre-checks
- Inspect the fog lamp bulb and make sure it is OK.