Brake Vacuum Pump - 2.7L EcoBoost (238kW/324PS): Removal
WARNING: This page is about a different car, the 2019 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
- Remove the upper RH air cleaner outlet pipe. Refer to: Air Cleaner Outlet Pipe RH .
- Remove the retainers and the engine under shield.
- Loosen the clamp and position the lower RH air cleaner outlet pipe away from the turbocharger.
Torque: 44 lb.in (5 Nm)
- Loosen the clamp and position the lower RH air cleaner outlet pipe away from the turbocharger.
Torque: 71 lb.in (8 Nm)
- Remove the air cleaner outlet pipe LH. Refer to: Air Cleaner Outlet Pipe LH .
- Loosen the clamp and position aside the CAC (charge air cooler) intake lower pipe RH.
Torque: 44 lb.in (5 Nm)
- Loosen the clamp and position aside the CAC (charge air cooler) intake lower pipe RH.
Torque: 44 lb.in (5 Nm)
-
- Disconnect the EVAP canister purge valve quick release coupling.
- Detach the retainer and position the EVAP canister purge valve tube aside.
- Detach the coolant hose from the starter motor bracket.
-
- Remove the bolt.
Torque: 71 lb.in (8 Nm)
- Disconnect the bypass valve electrical connector and remove the CAC intake pipe RH.
- Remove the bolt.
- Clean, inspect, and cover all open ports.
- Disconnect the vacuum tubes.
- Detach the wiring retainer.
- Remove the bolts and the vacuum pump.
Torque: 89 lb.in (10 Nm)