LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion SEL >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes (2 Of 2) (Except Hybrid) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test Bf : The Ignition-Engine On Warning Chime Is Inoperative >> Pinpoint Test Bf : The Ignition-Engine On Warning Chime Is Inoperative

Pinpoint Test Bf : The Ignition-Engine On Warning Chime Is Inoperative

  1. BF1 CHECK THE SAFETY BELT WARNING CHIME OPERATION

    • Ignition OFF.

    • Ignition ON.

    • Unbuckle the driver safety belt.

    • Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.

    Does the safety belt warning chime operate for approximately 6 seconds? 

    Yes  GO to  BF2
    No  IPC Guided Routine Testing

  2. BF2 CHECK THE DOOR AJAR INDICATION

    • Open the driver door.

    • Observe the door ajar warning indicator or door ajar RTT warning indicator.

    Does the door ajar warning indicator or door ajar RTT warning indicator turn on with the driver door ajar? 

    Yes  GO to  BF3
    No  For the door ajar warning indicator, GO to Pinpoint Test R  For the door ajar, RTT warning indicator, GO to Pinpoint Test AP 

  3. BF3 CHECK THE PRNDL OPERATION

    • Shift the transmission range selector through the ranges while observing the PRNDL indication.

    Does the PRNDL indication match the selected transmission range? 

    Yes  GO to  BF4
    No  GO to Pinpoint Test AB 

  4. BF4 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to DTC Chart - IPC  .
    No  DIAGNOSE all GWM Diagnostic Trouble Codes (DTCs) REFER to: Communications Network .
scientia non olet · About LEMON Manuals