LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Fusion S >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes (2 Of 2) (Except Hybrid) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test Be : The Headlamps On Warning Chime Is Inoperative >> Pinpoint Test Be : The Headlamps On Warning Chime Is Inoperative

Pinpoint Test Be : The Headlamps On Warning Chime Is Inoperative

  1. BE1 CHECK THE SAFETY BELT WARNING CHIME OPERATION

    • Ignition OFF.

    • Ignition ON.

    • Unbuckle the driver safety belt.

    • Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.

    Does the safety belt warning chime operate for approximately 6 seconds? 

    Yes  GO to  BE2
    No  IPC Guided Routine Testing

  2. BE2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to DTC Chart - IPC  .
    No  GO to  BE3

  3. BE3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Communications Network .
    No  DIAGNOSE all BCM Diagnostic Trouble Codes (DTCs). REFER to: Body Control Module (BCM) .
scientia non olet · About LEMON Manuals