Pinpoint Test E : The Speedometer Is Inoperative
- E1 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Ignition ON.
- Using a diagnostic scan tool, perform the IPC self-test.
- Check for recorded Diagnostic Trouble Codes (DTCs) from the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to DTC Chart - IPC . No GO to E2 - E2 PERFORM THE ABS (ANTI-LOCK BRAKE SYSTEM) MODULE SELF-TEST
- Using a diagnostic scan tool, perform the ABS module self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Anti-Lock Brake System (ABS) and Stability Control . No GO to E3 - E3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Communications Network . No GO to E4 - E4 PERFORM THE SPEEDOMETER ACTIVE COMMAND USING A DIAGNOSTIC SCAN TOOL
- Using a diagnostic scan tool, view the IPC Parameter Identifications (PIDs).
- Select the IPC speedometer (SPDOMETER) PID.
- Command the speedometer on and off while monitoring the speedometer.
Does the speed begin at 0 km/h (0 mph) move to 257 km/h (160 mph) and return to 0 km/h (0 mph)?
Yes DIAGNOSE all PCM Diagnostic Trouble Codes (DTCs). REFER to the appropriate Electronic Engine Controls article . No IPC Guided Routine Testing