LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Escape Titanium Plug-In Hybrid >> Repair and Diagnosis >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center And Warning Chimes (2 Of 2) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AZ : The Off Road Display Is Inoperative

Pinpoint Test AZ : The Off Road Display Is Inoperative

  1. Normal Operation and Fault Conditions 

    See Off Road Display. REFER to: Message Center - System Operation and Component Description .

    If the vehicle pitch angle display, vehicle roll angle display, steering wheel angle, stability-traction control or AWD status message is missing for less than 5 seconds, the IPC defaults the off road display based on the last message received.

    If the vehicle pitch angle display, vehicle roll angle display, steering wheel angle, stability-traction control or AWD status message is missing for 5 seconds or longer, the IPC defaults the off road display to 0 with the text display blank.

    Possible Sources 

    • Communication concern
    • ABS module concern
    • AWD module concern
    • GWM concern
    • IPC

  2. AZ1 VERIFY THE IPC (INSTRUMENT PANEL CLUSTER) IS SET TO THE OFF ROAD DISPLAY SCREEN

    • Ignition ON.

    • NOTE: The IPC and message center navigation can be found in the Owner's Literature.

      Using the message center controls, make sure the IPC is set to display the off road display screen.

    Is the IPC set to the off road display screen? 

    Yes  GO to  AZ2
    No  The off road display is operating correctly. The IPC was not set to the correct display screen.
  3. AZ2 PERFORM THE ABS (ANTI-LOCK BRAKE SYSTEM) MODULE SELF-TEST

    • Using a diagnostic scan tool, perform the ABS module self-test.

    • Check for recorded Diagnostic Trouble Codes (DTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to the Master DTC Chart.
    No  GO to  AZ3
  4. AZ3 PERFORM THE AWD (ALL-WHEEL DRIVE) MODULE SELF-TEST

    • Using a diagnostic scan tool, perform the AWD module self-test.

    • Check for recorded Diagnostic Trouble Codes (DTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to the Master DTC Chart.
    No  GO to  AZ4
  5. AZ4 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Communications Network .
    No  Refer to IPC Guided Routine Testing .