DTC Chart: IPC
Diagnostics in this information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| Module | DTC | Description | Action |
|---|---|---|---|
| HUD | B1558:9E | Head Up Display (HUD) Switch:Stuck On | GO to Pinpoint Test A |
| HUD | U0100:00 | Lost Communication With ECM/PCM "A":No Sub Type Information | GO to Pinpoint Test G |
| HUD | U0140:00 | Lost Communication With Body Control Module:No Sub Type Information | GO to Pinpoint Test H |
| HUD | U0146:00 | Lost Communication With Gateway "A":No Sub Type Information | GO to Pinpoint Test I |
| HUD | U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module:No Sub Type Information | GO to Pinpoint Test J |
| HUD | U0212:00 | Lost Communication With Steering Column Control Module:No Sub Type Information | GO to Pinpoint Test K |
| HUD | U0212:87 | Lost Communication With Steering Column Control Module:Missing Message | GO to Pinpoint Test K |
| HUD | U023A:00 | Lost Communication With Image Processing Module A:No Sub Type Information | GO to Pinpoint Test L |
| HUD | U0253:87 | Lost Communication With Accessory Protocol Interface Module:Missing Message | GO to Pinpoint Test M |
| HUD | U0401:00 | Invalid Data Received from ECM/PCM A:No Sub Type Information | GO to Pinpoint Test G |
| HUD | U0401:82 | Invalid Data Received from ECM/PCM A:Alive/Sequence Counter Incorrect/Not Updated | GO to Pinpoint Test G |
| HUD | U0405:56 | Invalid Data Received From Cruise Control Module:Invalid/Incompatible Configuration | GO to Pinpoint Test Q |
| HUD | U2100:00 | Initial Configuration Not Complete:No Sub Type Information | GO to Pinpoint Test R |
| HUD | U2101:00 | Control Module Configuration Incompatible:No Sub Type Information | GO to Pinpoint Test R |
| HUD | U3000:04 | Control Module:System Internal Failures | GO to Pinpoint Test S |
| HUD | U3000:71 | Control Module:Actuator Stuck | GO to Pinpoint Test C |
| HUD | U3000:98 | Control Module:Component Or System Over Temperature | GO to Pinpoint Test N |
| HUD | U3003:16 | Battery Voltage:Circuit Voltage Below Threshold | GO to Pinpoint Test O |
| HUD | U3003:17 | Battery Voltage:Circuit Voltage Above Threshold | GO to Pinpoint Test P |
| HUD | U300A:64 | Ignition Switch:Signal Plausibility Failure | GO to Pinpoint Test T |