LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Escape Titanium Plug-In Hybrid >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center And Warning Chimes (1 Of 2) >> Description And Operation >> Instrument Panel Cluster (IPC) - System Operation and Component Description >> Network Message Chart - Gauges, Hybrid

Network Message Chart - Gauges, Hybrid

Module Network Input Messages - IPC 

Broadcast Message Originating Module Message Purpose
Battery state of charge data BECM Input used to display the current available high voltage battery charge.
Engine coolant temperature data PCM Input used for the analog and virtual temperature gauge indication.
Engine overheat indication request PCM Input used to send the analog and virtual temperature gauge pointer to full hot.
Fuel level display PCM Input used to send the fuel level gauge pointer to the appropriate calculated fuel level.
Heater core temperature PCM Input used for the analog and virtual temperature gauge.
Ignition status BCM Ignition RUN, START and accessory states required for the IPC operating modes and fault reporting.
Power regeneration average display SOBDMC Input used to indicate the power sent to the wheels while driving and power captured by the regenerative braking system and returned to the high voltage battery.
Vehicle speed PCM Vehicle speed data used for the speedometer indication.

Module Network Input Messages - PCM 

Broadcast Message Originating Module Message Purpose
Fuel level data IPC Fuel level data obtained from the fuel pump and sender unit (hardwired to the IPC) and sent to the PCM to calculate the actual fuel level.
scientia non olet · About LEMON Manuals