LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Escape Titanium Plug-In Hybrid >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center And Warning Chimes (1 Of 2) >> Description And Operation >> Instrument Panel Cluster (IPC) - System Operation and Component Description >> Network Message Chart - Gauges, Gas

Network Message Chart - Gauges, Gas

Module Network Input Messages - IPC 

Broadcast Message Originating Module Message Purpose
AWD wheel lock display AWD module Input used for the AWD gauge.
Engine coolant temperature data PCM Input used for the analog and virtual temperature gauge indication.
Engine overheat indication request PCM Input used to send the analog and virtual temperature gauge pointer to full hot.
Engine rpm data PCM Input used for analog and virtual tachometer indication.
Fuel level display PCM Input used to send the fuel level gauge pointer to the appropriate calculated fuel level.
Ignition status BCM Ignition RUN, START and accessory states required for the IPC operating modes and fault reporting.
Vehicle speed PCM Vehicle speed data used for the speedometer indication.

Module Network Input Messages - PCM 

Broadcast Message Originating Module Message Purpose
Fuel level data IPC Fuel level data obtained from the fuel pump and sender unit (hardwired to the IPC) and sent to the PCM to calculate the actual fuel level.
scientia non olet · About LEMON Manuals