Rear Brake Flexible Hose: Removal

NOTE: Do not allow the brake fluid to come in contact with the adhesive backing on the brake pads. This may prevent the brake pad adhesive surface from bonding with the brake caliper. If brake fluid is spilled onto the brake pads, install new pads.

NOTE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: Make sure all openings are sealed.

NOTE: Removal steps in this procedure may contain installation details.

Remove the wheel and tire. Refer to: Wheel and Tire .
Remove the flow bolt and detach the brake hose. Discard the washers.
Torque: 30 lb.ft (40 Nm)

Courtesy of FORD MOTOR COMPANY
Remove the brake flexible hose.
1. Disconnect the brake tube.
  Torque: 159 lb.in (18 Nm)
2. Remove the clip and the brake flexible hose.

Courtesy of FORD MOTOR COMPANY