Pinpoint Test Ag : Impact Sensor Internal Faults
- Normal Operation and Fault Conditions
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition RCM B1413:81 Driver Frontal Restraints Sensor: Invalid Serial Data Received This DTC sets due to a fault with the Driver front impact severity sensor. RCM B1413:96 Driver Frontal Restraints Sensor: Component Internal Failure This DTC sets due to a fault with the Driver front impact severity sensor. RCM B1414:81 Driver Side Restraints Sensor 1: Invalid Serial Data Received This DTC sets due to a fault with the Driver door side impact sensor. RCM B1414:96 Driver Side Restraints Sensor 1: Component Internal Failure This DTC sets due to a fault with the Driver door side impact sensor. RCM B1415:81 Driver Side Restraints Sensor 2: Invalid Serial Data Received This DTC sets due to a fault with the Driver Side C-pillar side impact sensor. RCM B1415:96 Driver Side Restraints Sensor 2: Component Internal Failure This DTC sets due to a fault with the Driver Side C-pillar side impact sensor. RCM B1417:81 Passenger Frontal Restraints Sensor: Invalid Serial Data Received This DTC sets due to a fault with the Passenger front impact severity sensor. RCM B1417:96 Passenger Frontal Restraints Sensor: Component Internal Failure This DTC sets due to a fault with the Passenger front impact severity sensor. RCM B1418:81 Passenger Side Restraints Sensor 1: Invalid Serial Data Received This DTC sets due to a fault with the Passenger Door side impact sensor. RCM B1418:96 Passenger Side Restraints Sensor 1: Component Internal Failure This DTC sets due to a fault with the Passenger Door side impact sensor. RCM B1419:81 Passenger Side Restraints Sensor 2: Invalid Serial Data Received This DTC sets due to a fault with the Passenger Side C-pillar side impact sensor. RCM B1419:96 Passenger Side Restraints Sensor 2: Component Internal Failure This DTC sets due to a fault with the Passenger Side C-pillar side impact sensor. Possible Sources
- Impact sensor
- WARNING: Do not handle, move or change the original horizontal mounting position of the Restraints Control Module (RCM) while the Restraints Control Module (RCM) is connected and the ignition switch is ON. Failure to follow this instruction may result in the accidental deployment of the Safety Canopy® and cause serious personal injury or death.
- NOTE: Always make sure the correct SRS component is being installed. Parts released for other vehicles may not be compatible even if they appear physically similar. Check the part number listed in the Ford parts catalog to make sure the correct component is being installed. If an incorrect SRS component is installed, Diagnostic Trouble Codes (DTCs) may set.
- NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- AG1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, clear all Diagnostic Trouble Codes (DTCs).
- Using a diagnostic scan tool, perform the RCM self-test.
Did the DTC return?
Yes INSTALL a new suspect impact sensor. For a front impact severity sensor, REFER to: Front Impact Severity Sensor . For a front door side impact sensor, REFER to: Front Door Side Impact Sensor . For a C-pillar side impact sensor, REFER to: C-Pillar Side Impact Sensor . No The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.