LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Escape SE, FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System - Pinpoint Tests Aa - AZ >> Pinpoint Test AU : B1492:68

Pinpoint Test AU : B1492:68

  1. Normal Operation and Fault Conditions 

    This DTC is set when a fuel cutoff event has occurred and cutoff was requested by the RCM via the ENS (Event Notification System) and/or HS-CAN. Fault is cleared when and Event Complete message is received from the PCM.

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    RCM B1492:68 Fuel Cutoff Event: Event Information This DTC set with RCM has requested a fuel shutoff event and has not received and Event Complete message from the PCM.

    Possible Sources 

    • A crash has occurred.

  2. NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

  3. AU1 RESET THE ENS (EVENT NOTIFICATION SYSTEM)

    • Inspect the fuel system for damage.

    • Ignition OFF.
      NOTE: Use the following steps to reset the ENS (Event Notification System). The steps must be completed within 5 seconds.

    • Ignition ON.

    • Ignition OFF.

    • Ignition ON.

    Were any fuel system concerns found? 

    Yes  REPAIR as necessary.
    No  REPAIR is complete.
scientia non olet · About LEMON Manuals