Turbocharger Coolant Supply Tube: Installation
-
NOTE: Component(s) must be lubricated with clean engine coolant.
Install the new the turbocharger coolant tube O-ring seals, lubricate with clean engine coolant. Refer to: Specifications .
-
NOTE: Do not use a metal brush, damage to sealing area will result in leaks.
- Carefully use a nylon brush to remove the old O-ring residue and use brake cleaner to rinse the O-ring residue out of the turbocharger O-ring bore and the engine O-ring bore. Inspect the area for deep scratches and gouges. Install new components if needed.
- Install the turbocharger supply tube, then install and tighten the bolt. Attach the wire connector retainer.
Material: Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B
Torque: 89 lb.in (10 Nm)
- Install and tighten the bracket bolt.
Torque: 89 lb.in (10 Nm)
- Connect the turbocharger coolant tube, tighten the turbocharger coolant tube bolt. Then install and tighten the bracket bolt.
Torque: 89 lb.in (10 Nm)
- Install the catalytic converter. Refer to: Catalytic Converter . Refer to: Catalytic Converter - 4WD .
- Install the air cleaner. Refer to: Air Cleaner .
- Install the air cleaner intake pipe. Refer to: Air Cleaner Intake Pipe .
- Install the air cleaner outlet pipe. Refer to: Air Cleaner Outlet Pipe .
- Install the cowl panel grille. Refer to: Cowl Panel Grille .
- Fill and bleed the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .