LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Edge ST-Line, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Parking Brake And Actuation - Vehicles With: Electronic Parking Brake (EPB)) >> Diagnosis And Testing >> Parking Brake - Vehicles With: Electric Brake Booster >> Pinpoint Tests >> Pinpoint Test F : B1111:53

Pinpoint Test F : B1111:53

WARNING: This page is about a different car, the 2020 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Normal Operation and Fault Conditions 

    REFER to: Parking Brake - System Operation and Component Description .

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    ABS B1111:53 Electric Park Brake Enable: Deactivated This DTC sets when both parking brake actuators do not reset when exiting the Maintenance Mode routine. This is most likely caused by an interrupted Maintenance Mode routine.

    Possible Sources 

    • The EPB Apply and Release routine was not carried out.

  2. F1 CARRY OUT THE EPB APPLY AND RELEASE ROUTINE

    • Using a diagnostic scan tool, carry out the EPB Apply and Release routine.

    • Ignition OFF.

    • Ignition ON.

    • Using a diagnostic scan tool, clear the ABS DTC.

    • Using a diagnostic scan tool, carry out the ABS self-test.

    Is DTC B1111:53 set? 

    Yes  Exit Maintenance mode REFER to: Electronic Parking Brake (EPB) Service Mode Activation and Deactivation .
    No  The system is operating correctly at this time. The EPB Apply and Release routine cleared the DTC.