LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Edge SE, FWD >> Repair and Diagnosis (Single Page) >> Brakes >> Parking Brake System >> Parking Brake And Actuation >> General Procedures >> Electronic Parking Brake (EPB) Service Mode Activation and Deactivation >> Deactivation

Electronic Parking Brake (EPB) Service Mode Activation and Deactivation: Deactivation

NOTE: Carry out the following service mode deactivation procedure to activate the EPB system.
  1. Set the ignition to ON.
  2. Press and hold the accelerator pedal and place the EPB switch in the APPLY (upward) position. Continue to hold the accelerator pedal and the EPB switch.
  3. Set the ignition to OFF then set the ignition to ON within 5 seconds  . Continue to hold the accelerator pedal and the EPB switch.
  4. NOTE: The EPB system will fully apply and release the parking brake to guarantee sufficient air gap between the rear brake pads and brake disc.

    Release the accelerator pedal and the EPB switch.

scientia non olet · About LEMON Manuals