LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2020 >> Edge SE, FWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Front End Body Panels >> Removal And Installation >> Hood >> Removal

Removal And Installation: Hood: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. Detach the windshield washer hose coupling.
    GFD528809Courtesy of FORD MOTOR COMPANY
  2. Detach the windshield washer hose retainers from the RH side hood hinge and cowl panel.
    GFD528810Courtesy of FORD MOTOR COMPANY
  3. NOTE: LH side shown, RH side similar.

    Index-mark the hood hinge location to aid in hood installation.

    GFD528811Courtesy of FORD MOTOR COMPANY
  4. NOTE: An assistant is necessary to support the hood.

    Remove the clips and the hood struts.

    GFD528812Courtesy of FORD MOTOR COMPANY
  5. NOTE: An assistant is necessary for the support and removal of the hood.

    Remove the nuts and the hood.

    Torque: 18 lb.ft (25 Nm)

    GFD528813Courtesy of FORD MOTOR COMPANY
  6. NOTE: This step is only necessary when installing a new component.

    Remove the retainers and the hood insulation.

    GFD528814Courtesy of FORD MOTOR COMPANY
  7. NOTE: This step is only necessary when installing a new component.

    Release the retainers, couplings and remove the windshield washer hose and the washer jets.

    GFD528815Courtesy of FORD MOTOR COMPANY
  8. NOTE: This step is only necessary when installing a new component.

    Remove the nuts and the striker latch.

    Torque: 80 lb.in (9 Nm)

    GFD528816Courtesy of FORD MOTOR COMPANY
  9. NOTE: This step is only necessary when installing a new component.

    Remove the hood bump stop rubbers.

    GFD528817Courtesy of FORD MOTOR COMPANY
  10. NOTE: This step is only necessary when installing a new component.

    Remove the retainers and the hood pad assembly.

GFD528818Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals