Instrument Panel Cluster (IPC): Removal
NOTE:
It is critical that the correct Instrument Panel Cluster(IPC) be installed when installing a new IPC. The IPC differs between Passive Anti-Theft System(PATS) vehicles equipped with Intelligent Access(IA) and vehicles not equipped with IA. If the incorrect IPC is installed, the vehicle may exhibit a PATS no-start condition.
NOTE:
If installing a new IPC, all vehicle keys are erased during the parameter reset procedure. Verify at least 2 of the vehicle keys are available prior to carrying out this procedure.
- If installing a new IPC, upload the module configuration information to the scan tool. For additional information, refer to Module Configuration .
- Remove the IPC finish panel. For additional information, refer to Instrument Panel and Console .
- Remove the 4 screws and the IPC.
- Disconnect the electrical connector.