Bezel Diagnostics

For information on Ford Color Coded Illustrations, refer to OEM COLOR CODING

• Inoperative (blank or does not power on) FDIM
• Inoperative FCIM
• Inoperative steering wheel switch (for vehicles without a CD player)

Refer to appropriate Information and Entertainment Information to diagnose the inoperative component.

1. Ignition ON
2. Operate the audio system in AM/FM mode.
   • For vehicles with  a CD player, press and hold the EJECT button, and within 1 second, press and hold the SEEK UP button. If supported, the Speaker Walk-Around Test will begin, and the display will indicate each speaker as it is tested.
   • For vehicles without  a CD player, simultaneously press and hold the steering wheel SEEK UP switch and FCIM TUNE UP button. If supported, the Speaker Walk-Around Test will begin, and the display will indicate each speaker as it is tested.

3. Once the Speaker Walk-Around Test (All Speaker Test) is complete, the following information is available:

   Menu	Submenu
   APIM Diagnostics	Part Numbers
   	Software Versions
   	Configuration Status
   	Location Information
   	Tones Test
   	Touchscreen Activation Test
   	Display Test Pattern
   	RGB Pixel Test
   	IVSU Versions
   	Exit Diagnostics
   AHU Diagnostics (AHU refers to the ACM)	AHU Part Numbers (also displays SIRIUS ESN)
   	Radio Signal Strength
   	Speaker Walk-Around Test Active (if not  equipped with audio DSP module)
   	Exit Diagnostics
   DSP Diagnostics (if equipped)	DSP Part Numbers
   	Speaker Walk-Around Test Active
   	Exit Diagnostics
   EFP Diagnostics - if equipped (EFP refers to the FCIM that communicates on the CAN)	EFP Part Numbers
   	Exit Diagnostics

4. To exit the bezel diagnostics, press the FCIM on/off button or select "Exit Diagnostics."