LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2019 >> Fusion S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 77 (Information Center - Instrumentation, Message Center And Warning Chimes (2 Of 2) (Hybrid/ENERGI)) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes - 2.0L Duratec - Hybrid (103kW/140PS) (UA) >> Pinpoint Tests >> Pinpoint Test BG : The Turn Signal-Hazard On Chime Or Turn Signal Left On Chime Is Inoperative >> Pinpoint Test BG : The Turn Signal-Hazard On Chime Or Turn Signal Left On Chime Is Inoperative

Pinpoint Test BG : The Turn Signal-Hazard On Chime Or Turn Signal Left On Chime Is Inoperative

WARNING: This page is about a different variant/trim than selected.

  1. BG1 CHECK THE SAFETY BELT WARNING CHIME OPERATION

    • Ignition OFF.

    • Ignition ON.

    • Unbuckle the driver safety belt.

    • Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.

    Does the safety belt warning chime operate for approximately 6 seconds? 

    Yes  GO to  BG2
    No  Refer to IPC Guided Routine .

  2. BG2 CHECK THE TURN SIGNAL INDICATOR OPERATION

    • Verify the RH and LH turn signal indicators operate correctly.

    Do the turn signal indicators operate correctly? 

    Yes  GO to  BG3
    No  GO to Pinpoint Test L 

  3. BG3 PERFORM THE BCM (BODY CONTROL MODULE) SELF-TEST

    • Using a diagnostic scan tool, perform the BCM self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Body Control Module (BCM) .
    No  Refer to IPC Guided Routine .
scientia non olet · About LEMON Manuals