Pinpoint Test Ar : The Active Park Assist/Parking Aid Chime Is Inoperative
WARNING: This page is about a different variant/trim than selected.
- AR1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Unbuckle the driver safety belt.
- Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?
Yes GO to AR2 No Refer to IPC Guided Routine . - AR2 VERIFY THE CHIMES FUNCTION THROUGH THE AUDIO SPEAKERS
- Ignition OFF.
- Ignition ON.
- Monitor the location of the safety belt warning chime (front/rear audio speakers or IPC) when the ignition is transitioned from OFF to RUN.
Does the chime sound through the audio speakers?
Yes GO to AR3 No GO to Pinpoint Test AV - AR3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Communications Network - 2.0L Duratec - Hybrid (103kW/140PS) (UA) . No GO to AR4 - AR4 PERFORM THE PAM (PARKING ASSIST CONTROL MODULE) SELF-TEST
- Using a diagnostic scan tool, perform the PAM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Parking Aid . REFER to: Vehicles With: Active Park Assist Parking Aid . No GO to AR5 - AR5 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to DTC Chart: IPC . No DIAGNOSE the audible parking aid. REFER to: Parking Aid . REFER to: Vehicles With: Active Park Assist Parking Aid .