Brake Fluid Reservoir: Removal

NOTE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: Removal steps in this procedure may contain installation details.

Disconnect the electrical connector, remove the screws and the headlamp assembly.

Courtesy of FORD MOTOR COMPANY
Remove the bolt and position the cowl vent panel upward.
Torque: 62 lb.in (7 Nm)

Courtesy of FORD MOTOR COMPANY
Using a suitable suction device, remove the brake fluid from the remote reservoir and then remove the nuts.
Material: Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20 (WSS-M6C65-A2)

Torque: 62 lb.in (7 Nm)

Courtesy of FORD MOTOR COMPANY
Release the coupling and remove the remote brake fluid reservoir.

Courtesy of FORD MOTOR COMPANY