| A module does not communicate with the diagnostic scan tool |
Refer to the Pinpoint Test |
REFER to: Communications Network
. |
| The audible parking aid is inoperative or does not operate correctly |
Refer to the Pinpoint Test |
GO to Pinpoint Test A |
| Continuous or intermittent tone when no obstacles or fault codes are present |
Dirty or iced over parking aid sensor(s) |
CLEAN the rear bumper and sensors with high-pressure water. |
| Ice between parking aid sensor(s) and bezel(s) |
ALLOW time for the ice between the parking aid sensor(s) and bezel(s) to melt. |
| Parking aid sensor(s) locked into the rear bumper incorrectly |
INSTALL the parking aid sensor(s) into the parking aid sensor bezel(s) correctly. |
| Parking aid sensor(s) are not aligned correctly |
CARRY OUT the azimuth and elevation system check. REFER to: Elevation System Check . |
| Parking aid sensor(s) isolator ring missing, damaged or misaligned |
INSTALL a new parking aid sensor. REFER to: Front Parking Aid Sensor .
REFER to: Rear Parking Aid Sensor . |
| The parking aid disable switch is inoperative or does not operate correctly |
Refer to the Pinpoint Test |
GO to Pinpoint Test K |
| The parking aid menu is not available in the message center and cannot be deactivated |
A MyKey restricted key is in use |
Normal operation. |