| B129C:12 |
Left Front Side Sensor: Circuit Short To Battery |
REFER to: Parking Aid
. |
| B129C:14 |
Left Front Side Sensor: Circuit Short To Ground or Open |
REFER to: Parking Aid
. |
| B129C:96 |
Left Front Side Sensor: Component Internal Failure |
REFER to: Parking Aid
. |
| B129D:12 |
Right Front Side Sensor: Circuit Short To Battery |
REFER to: Parking Aid
. |
| B129D:14 |
Right Front Side Sensor: Circuit Short To Ground or Open |
REFER to: Parking Aid
. |
| B129D:96 |
Right Front Side Sensor: Component Internal Failure |
REFER to: Parking Aid
. |
| B129E:73 |
Enable/Disable Switch - Semi-Automatic Advanced Parallel Park: Actuator Stuck Closed |
REFER to: Parking Aid
. |
| B1303:11 |
Park Assist Switch: Circuit Short To Ground |
GO to Pinpoint Test K |
| B13F3:12 |
Left Rear Side Sensor: Circuit Short To Battery |
REFER to: Parking Aid
. |
| B13F3:14 |
Left Rear Side Sensor: Circuit Short To Ground or Open |
REFER to: Parking Aid
. |
| B13F3:96 |
Left Rear Side Sensor: Component Internal Failure |
REFER to: Parking Aid
. |
| B13F4:12 |
Right Rear Side Sensor: Circuit Short To Battery |
REFER to: Parking Aid
. |
| B13F4:14 |
Right Rear Side Sensor: Circuit Short To Ground or Open |
REFER to: Parking Aid
. |
| B13F4:96 |
Right Rear Side Sensor: Component Internal Failure |
REFER to: Parking Aid
. |
| B1B36:12 |
Right Front Outer Sensor: Circuit Short To Battery |
GO to Pinpoint Test G |
| B1B36:14 |
Right Front Outer Sensor: Circuit Short To Ground or Open |
GO to Pinpoint Test H |
| B1B36:96 |
Right Front Outer Sensor: Component Internal Failure |
GO to Pinpoint Test I |
| B1B38:12 |
Right Front Inner Sensor: Circuit Short To Battery |
GO to Pinpoint Test G |
| B1B38:14 |
Right Front Inner Sensor: Circuit Short To Ground or Open |
GO to Pinpoint Test H |
| B1B38:96 |
Right Front Inner Sensor: Component Internal Failure |
GO to Pinpoint Test I |
| B1B40:12 |
Left Front Outer Sensor: Circuit Short To Battery |
GO to Pinpoint Test G |
| B1B40:14 |
Left Front Outer Sensor: Circuit Short To Ground or Open |
GO to Pinpoint Test H |
| B1B40:96 |
Left Front Outer Sensor: Component Internal Failure |
GO to Pinpoint Test I |
| B1B42:12 |
Left Front Inner Sensor: Circuit Short To Battery |
GO to Pinpoint Test G |
| B1B42:14 |
Left Front Inner Sensor: Circuit Short To Ground or Open |
GO to Pinpoint Test H |
| B1B42:96 |
Left Front Inner Sensor: Component Internal Failure |
GO to Pinpoint Test I |
| B1B44:12 |
Right Rear Outer Sensor: Circuit Short To Battery |
GO to Pinpoint Test E |
| B1B44:14 |
Right Rear Outer Sensor: Circuit Short To Ground or Open |
GO to Pinpoint Test D |
| B1B44:96 |
Right Rear Outer Sensor: Component Internal Failure |
GO to Pinpoint Test F |
| B1B46:12 |
Right Rear Inner Sensor: Circuit Short To Battery |
GO to Pinpoint Test E |
| B1B46:14 |
Right Rear Inner Sensor: Circuit Short To Ground or Open |
GO to Pinpoint Test D |
| B1B46:96 |
Right Rear Inner Sensor: Component Internal Failure |
GO to Pinpoint Test F |
| B1B48:12 |
Left Rear Outer Sensor: Circuit Short To Battery |
GO to Pinpoint Test E |
| B1B48:14 |
Left Rear Outer Sensor: Circuit Short To Ground or Open |
GO to Pinpoint Test D |
| B1B48:96 |
Left Rear Outer Sensor: Component Internal Failure |
GO to Pinpoint Test F |
| B1B50:12 |
Left Rear Inner Sensor: Circuit Short To Battery |
GO to Pinpoint Test E |
| B1B50:14 |
Left Rear Inner Sensor: Circuit Short To Ground or Open |
GO to Pinpoint Test D |
| B1B50:96 |
Left Rear Inner Sensor: Component Internal Failure |
GO to Pinpoint Test F |
| B1B54:11 |
Function LED - Park Aid: Circuit Short To Ground |
GO to Pinpoint Test J |
| B1B54:12 |
Function LED - Park Aid: Circuit Short To Battery |
GO to Pinpoint Test J |
| B1B57:11 |
Front Sensors Power Circuit: Circuit Short To Ground |
GO to Pinpoint Test B |
| B1B58:11 |
Rear Sensors Power Circuit: Circuit Short To Ground |
GO to Pinpoint Test C |
| U0100:00 |
Lost Communication With ECM/PCM "A": No Sub Type Information |
GO to Pinpoint Test L |
| U0101:00 |
Lost Communication with TCM: No Sub Type Information |
GO to Pinpoint Test L |
| U0121:00 |
Lost Communication With Anti-Lock Brake System (ABS) Control Module: No Sub Type Information |
GO to Pinpoint Test M |
| U0131:00 |
Lost Communication With Power Steering Control Module: No Sub Type Information |
GO to Pinpoint Test N |
| U0140:00 |
Lost Communication With Body Control Module: No Sub Type Information |
GO to Pinpoint Test O |
| U0155:00 |
Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information |
GO to Pinpoint Test P |
| U0257:00 |
Lost Communication With Front Controls / Display Interface Module: No Sub Type Information |
GO to Pinpoint Test Q |
| U0401:00 |
Invalid Data Received from ECM/PCM A: No Sub Type Information |
This DTC sets when the PAM receives invalid network data from the PCM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0402:00 |
Invalid Data Received from TCM: No Sub Type Information |
This DTC sets when the PAM receives invalid network data from the TCM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0415:00 |
Invalid Data Received From Anti-Lock Brake System (ABS) Control Module: No Sub Type Information |
This DTC sets when the PAM receives invalid network data from the ABS module with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0420:00 |
Invalid Data Received From Power Steering Control Module: No Sub Type Information |
A continuous and on-demand DTC that sets when the PAM receives an invalid network data from the PSCM with a faulted signal data input and or a loss of PSCM synchronization occurred. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in other modules on the network. If no Diagnostic Trouble Codes (DTCs) are present in the PSCM drive the vehicle above 50 km/h (30 mph) for a minimum distance of 1 mile while maintaining a straight ahead vehicle position for at least 30 seconds (this drive cycle needs to occur if the battery has been disconnected or if vehicle is new). If the active park assist is still inoperative and the U0420:00 DTC does not return after driving the vehicle for 1 mile and clearing Diagnostic Trouble Codes (DTCs). DIAGNOSE the observable symptom. |
| U0422:00 |
Invalid Data Received From Body Control Module: No Sub Type Information |
This DTC sets when the PAM receives invalid network data from the BCM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0423:00 |
Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information |
This DTC sets when the PAM receives invalid network data from the IPC with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0558:00 |
Invalid Data Received From Front Controls / Display Interface Module: No Sub Type Information |
This DTC sets when the PAM receives invalid network data from the FCDIM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U2100:00 |
Initial Configuration Not Complete: No Sub Type Information |
CLEAR the DTC and turn the ignition OFF. Turn the ignition ON, wait 30 seconds and TEST the system for normal operation. If the DTC returns, INSTALL a new PAM. REFER to: Parking Assist Control Module (PAM) . |
| U2101:00 |
Control Module Configuration Incompatible: No Sub Type Information |
CLEAR the DTC and turn the ignition OFF. Turn the ignition ON, wait 30 seconds and TEST the system for normal operation. If the DTC returns, INSTALL a new PAM. REFER to: Parking Assist Control Module (PAM) . |
| U2024:41 |
Control Module Cal-Config Data: General Checksum Failure |
CLEAR the DTC and turn the ignition OFF. Turn the ignition ON, wait 30 seconds and TEST the system for normal operation. If the DTC returns, INSTALL a new PAM. REFER to: Parking Assist Control Module (PAM) . |
| U3000:45 |
Control Module: Program Memory Failure |
CLEAR the DTC and turn the ignition OFF. Turn the ignition ON, wait 30 seconds and TEST the system for normal operation. If the DTC returns, INSTALL a new PAM. REFER to: Parking Assist Control Module (PAM) . |
| U3000:46 |
Control Module: Calibration / Parameter Memory Failure |
CLEAR the DTC and turn the ignition OFF. Turn the ignition ON, wait 30 seconds and TEST the system for normal operation. If the DTC returns, INSTALL a new PAM. REFER to: Parking Assist Control Module (PAM) . |