Turbocharger Oil Supply Tube LH: Installation
- Install the new turbocharger oil supply tube O-ring seals and the new turbocharger oil supply tube oil filter. Lubricate the new O-ring seals with clean engine oil. Refer to: Specifications
-
NOTE: Do not use a metal brush, damage to sealing area will result in leaks.NOTE: When installing the turbocharger oil supply tube into the engine block, use care not to damage the new turbocharger oil supply tube oil filter.
- Carefully use a nylon brush to remove the old O-ring residue and use brake cleaner to rinse the O-ring residue out of the turbocharger tube to turbocharger O-ring bore and the turbocharger tube to engine O-ring bore. Inspect the area for deep scratches and gouges. Install new components as needed.
- Install the turbocharger oil supply tube, then install and tighten the turbocharger oil supply tube bolts.
Material: Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B
Torque: 89 lb.in (10 Nm)
- Attach the electrical connector retainer, then attach the electrical harness retainers to the valve cover studbolts and the valve cover.
-
NOTE: If equipped with the sensor in the following step, only the lower heat shield bolt will need to be installed at this time.
Install the turbocharger heat shield, then install and tighten the turbocharger heat shield bolts.
Torque: 89 lb.in (10 Nm)
- If equipped, install the bracket and sensor, then install and tighten the bolt.
Torque: 89 lb.in (10 Nm)
- Install the generator. Refer to: Generator - 2.7L EcoBoost (238kW/324PS)
- Install the catalytic converter LH. Refer to: Catalytic Converter LH
-
NOTE: If equipped with the sensor in the following step, only the lower heat shield bolt will need to be installed at this time.
Install the turbocharger heat shield, then install and tighten the turbocharger heat shield bolts.
Torque: 89 lb.in (10 Nm)
- Check and top off the engine oil level as needed. Refer to: Specifications