Disc Rotor: Remove & Replace
WARNING: This page is about the Transit-350 HD Base, 2D Cab Chassis, 3.2L Eng VIN V, which is a different variant/trim than selected.
Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Front,Both | 2.3 | B | ||
| Front,One | 1.4 | B | ||
| Rear,Both,w/Dual Rear Wheels | Includes: R&I Axle Shaft. | 2.7 | B | |
| Rear,Both,w/Single Rear Wheels | Includes: R&I Axle Shaft. | 2.1 | B | |
| Rear,One Side,w/Dual Rear Wheels | Includes: R&I Axle Shaft. | 1.9 | B | |
| Rear,One Side,w/Single Rear Wheels | Includes: R&I Axle Shaft. | 1.5 | B | |
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR (REMOVED): Refinish: DOES NOT include grind hot spots. | ||||
| Each Additional | 0.3 | B | ||
| One | 0.5 | B | ||