DTC P2033 - Exhaust Gas Temperature Sensor Circuit High Bank 1 Sensor 2
WARNING: This page is about a different variant/trim than selected.
P2033 - EXHAUST GAS TEMPERATURE SENSOR CIRCUIT HIGH BANK 1 SENSOR 2
| Description: | This DTC sets when the exhaust gas temperature sensor bank 1, sensor 2 (EGT12) voltage is greater than 4.90 volts for greater than 15 seconds. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | The presence of this DTC may indicate that the vehicle is operating in derate mode and may experience a loss of power. After repair, the vehicle may still display a system warning message. Drive the vehicle, while carrying out the appropriate drive cycle procedure, until the system warning message has cleared from the instrument cluster message center. Refer to DRIVE CYCLES
for additional information. An EGT12_V PID value greater than 4.90 volts indicates a concern. |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST RC . | ||