DTC P2031 - Exhaust Gas Temperature Sensor Circuit Bank 1 Sensor 2
WARNING: This page is about a different variant/trim than selected.
P2031 - EXHAUST GAS TEMPERATURE SENSOR CIRCUIT BANK 1 SENSOR 2
| Description: | The PCM monitors the operation of the exhaust gas temperature bank 1, sensor 2 (EGT12) to determine if the EGT12 sensor responds to the increase in temperature of the exhaust gas, during vehicle operation. The PCM then compares the measured temperature to a modeled value. This DTC sets when, after 5 minutes of driving, following a 6 hour soak, the EGT12 sensor temperature does not correlate to the modeled temperature of 150°C (302° F). | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Monitor the EGT12 PID between ignition ON, engine OFF and ignition ON, engine running for an indication of a concern. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST RC . | ||