DTC P0343 - Camshaft Position Sensor A Circuit High (Bank 1 Or Single Sensor)
WARNING: This page is about a different variant/trim than selected.
P0343 - CAMSHAFT POSITION SENSOR A CIRCUIT HIGH (BANK 1 OR SINGLE SENSOR)
| Description: | This DTC sets when the PCM detects the CMP11 circuit signal is beyond the minimum or maximum calibrated limit. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST V . | ||