DTC P0341 - Camshaft Position Sensor A Circuit Range/Performance (Bank 1 Or Single Sensor)
WARNING: This page is about a different variant/trim than selected.
P0341 - CAMSHAFT POSITION SENSOR A CIRCUIT RANGE/PERFORMANCE (BANK 1 OR SINGLE SENSOR)
| Description: | The PCM monitors the camshaft position 11 (CMP11) sensor and crankshaft position (CKP) sensor signals during engine cranking. This DTC sets when the CMP11 signal is inactive while the CKP signal indicates the engine is rotating. The PCM also monitors the CMP11 sensor signal for electrical noise. This DTC sets when the electrical noise exceeds the calibrated threshold. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Monitor the CMP_F PID while cranking the engine. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST V . | ||