DTC P0335 - Crankshaft Position Sensor A Circuit
WARNING: This page is about a different variant/trim than selected.
P0335 - CRANKSHAFT POSITION SENSOR A CIRCUIT
| Description: | This DTC sets when the crankshaft position (CKP) sensor signal is missing for greater than a calibrated number of camshaft revolutions. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | The presence of this DTC may indicate that the vehicle is operating in derate mode and may experience a loss of power. After repair, the vehicle may still display a system warning message. Drive the vehicle until the system warning message has cleared from the instrument cluster message center. Monitor the RPM PID while cranking the engine. A value of 0 RPM indicates a CKP concern. |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST D . | ||