DTC P0107 - Manifold Absolute Pressure (Map)/Barometric Pressure (BARO) Sensor Low
WARNING: This page is about a different variant/trim than selected.
P0107 - MANIFOLD ABSOLUTE PRESSURE (MAP)/BAROMETRIC PRESSURE (BARO) SENSOR LOW
| Description: | This DTC sets when the MAP signal voltage is lower than a specified value indicating an open circuit or a short to ground. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | The presence of this DTC may indicate that the vehicle is operating in derate mode and may experience a loss of power. After repair, the vehicle may still display a system warning message. Drive the vehicle until the system warning message has cleared from the instrument cluster message center. If the MAP sensor operating voltage is less than 0.1 volts for greater than 2 seconds, a concern is indicated. |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST E . | ||