DTC P0016 - Crankshaft Position - Camshaft Position Correlation - Bank 1 Sensor A
WARNING: This page is about a different variant/trim than selected.
P0016 - CRANKSHAFT POSITION - CAMSHAFT POSITION CORRELATION - BANK 1 SENSOR A
| Description: | This DTC sets if the location of the gap on the crankshaft position (CKP) sensor wheel is greater than 6 degrees from the expected location on the camshaft position 11 (CMP11) sensor wheel for two detection attempts. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Verify the CKP sensor has been installed and aligned correctly. Verify the CMP11 sensor has been installed and aligned correctly. |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST D . | ||