DTC U2101 - Control Module Configuration Incompatible
WARNING: This page is about a different variant/trim than selected.
U2101 - CONTROL MODULE CONFIGURATION INCOMPATIBLE
| Description: | This DTC sets when the PCM RAM has been corrupted. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Reprogram or update the calibration. Check for other DTCs or drive symptoms for further action. Check for aftermarket performance products before installing a new PCM. If necessary to install new PCM. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming the VID Block for a replacement PCM. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||