DTC P0010 - A Camshaft Position Actuator A Control Circuit/Open Bank 1

WARNING: This page is about a different variant/trim than selected.

P0010 - A CAMSHAFT POSITION ACTUATOR A CONTROL CIRCUIT/OPEN BANK 1

Description:	This DTC sets when a low or high voltage on the VCT11 circuit is detected.
Possible Causes:	VCT11 circuit open VCT11 circuit short to voltage VCT11 circuit short to ground VPWR circuit open Damaged variable camshaft timing bank 1 solenoid 1 (VCT11)
Diagnostic Aids:
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to PINPOINT TEST HK .