LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Transit-350 Base, Van Cargo Extended, 3.2L Eng VIN V >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 (Engine Controls - Pinpoint Test H: Fuel Control Through Pinpoint Test JE: Integrated Ignition Coil Pack - (Except Diesel & Hybrid)) >> Pinpoint Test Hd: Misfire Detection Monitor >> Introduction

Pinpoint Test Hd: Misfire Detection Monitor: Introduction

WARNING: This page is about a different variant/trim than selected.
NOTE: Mechanical noise caused by the front end accessory drive components, mechanically driven cooling fans, or rough roads at high RPM with light load conditions may produce a non-symmetrical loss of cylinder acceleration, which may result in a misfire.

This pinpoint test is intended to diagnose the misfire detection monitor.

Clearing the powertrain control module (PCM) diagnostic trouble codes (DTCs) erases any PCM recorded freeze frame data. Make sure to record any PCM freeze frame information before proceeding. Refer to FREEZE FRAME DATA .

scientia non olet · About LEMON Manuals