Pinpoint Test DT: Exhaust Pressure (EP) Sensor: Introduction
WARNING: This page is about a different variant/trim than selected.
This pinpoint test is intended to diagnose the following:
- harness circuits: EP, SIGRTN, VREF
- EP sensor (9J460)
- PCM (12A650)
| Pin | Circuit |
|---|---|
| 3 | EP (Exhaust Pressure) |
| 2 | SIGRTN (Signal Return) |
| 1 | VREF (Reference Voltage) |
Powertrain Control Module (PCM) Connector
For PCM connector views or reference values, refer to REFERENCE VALUES .
| Connector | Pin | Circuit |
|---|---|---|
| 306 PIN | E97 | EP |