Ignition Coil-On-Plug: Installation
WARNING: This page is about a different variant/trim than selected.
- Inspect the ignition coil-on-plugs and replace any ignition coil-on-plugs with any ignition coil-on-plug seal or rubber boot cracks, rips or tears.
- Install the ignition coil-on-plugs and the ignition coil-on-plug mounting bolts. Tighten the ignition coil-on-plug mounting bolts.
Torque: Stage 1: 62 lb.in (7 Nm) Stage 2: 50°
- Connect the ignition coil-on-plug electrical connector and connect the high-pressure fuel pump electrical connector.
-
NOTE: When removing or installing the high-pressure fuel pump noise insulator, spreading the openings will reduce the risk of damage.
Install the high-pressure fuel pump noise insulator. Install the high-pressure fuel pump noise insulator retainer.