LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Transit-350 Base, Van Cargo Extended, 3.2L Eng VIN V >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Electronic Engine Controls - 3.7L DURATEC (199KW/270PS)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different variant/trim than selected.
  1. To install, reverse the removal procedure.
  2. NOTE: This step is only necessary when installing a new component.

    Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Refer to: Module Configuration - System Operation And Component Description .

  3. NOTE: This step is only necessary when installing a new component.
    NOTE: Vehicles without PATS may still require a parameter reset.

    Carry out the Parameter Reset procedure. Refer to: Passive Anti-Theft System (PATS) Parameter Reset .

  4. NOTE: This step is only necessary when installing a new component.

    Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.

scientia non olet · About LEMON Manuals