LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Transit-350 Base, Van Cargo Extended, 3.2L Eng VIN V >> Repair and Diagnosis >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center And Warning Chimes (2 Of 2) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test Av : The Headlamps On Warning Chime Is Inoperative

Pinpoint Test Av : The Headlamps On Warning Chime Is Inoperative

  1. Normal Operation and Fault Conditions 

    See Headlamps On Warning Chime. REFER to: Warning Chimes - System Operation and Component Description .

    Possible Sources 

    • Door ajar indication concern
    • Interior lighting concern
    • Exterior lighting concern
    • BCM
    • IPC

  2. AV1 CHECK THE SAFETY BELT WARNING CHIME OPERATION

    • Ignition OFF.

    • Unbuckle the driver safety belt.

    • Ignition ON.

    • Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.

    Does the safety belt warning chime operate for approximately 6 seconds? 

    Yes  GO to  AV2
    No  GO to Pinpoint Test A 

  3. AV2 CHECK THE INTERIOR LAMPS OPERATION

    • Open and close the driver door.

    • Observe the interior lamps.

    Do the interior lamps operate correctly from the driver door? 

    Yes  GO to  AV3
    No  REFER to: Interior Lighting .

  4. AV3 CHECK THE EXTERIOR LAMPS OPERATION

    • Verify the exterior lamps operate correctly when switched on and turn off when switched off (after any headlamp delay [if equipped]).

    Do the exterior lamps operate correctly? 

    Yes  GO to  AV4
    No  REFER to: Interior Lighting .

  5. AV4 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST

    • Using a diagnostic scan tool, perform the BCM self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Body Control Module (BCM) .
    No  GO to  AV5

  6. AV5 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION

    • Ignition OFF.

    • Disconnect and inspect all BCM connectors.

    • Repair:

      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary

    • Reconnect the BCM connectors. Make sure they seat and latch correctly.

    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    Yes  CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new BCM. REFER to: Body Control Module (BCM) .
    No  The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.
scientia non olet · About LEMON Manuals