Azimuth System Check

For information on Ford Color Coded Illustrations refer to OEM Color Coding .

Check 

1. NOTE: The object used in this system check can be fabricated using a 9 cm diameter (3 in I.D.) pipe, 100 cm (39 in) in length (available as Polyvinyl Chloride (PVC) pipe, or similar from a hardware or plumbing supply.
   NOTE: The following system check should be carried out with the vehicle on a level surface.

   Arrange the test objects as shown. Refer to General Specifications - Rear Parking Aid .

   Courtesy of FORD MOTOR COMPANY

2. Turn the ignition switch to the ON position, engine off.
3. Apply the parking brake.
4. Select REVERSE (R) for rear parking aid.
5. Select DRIVE (D) for front parking aid.
6. NOTE: The speaker should beep slowly when objects are detected on the outer edges of the detection zone, and increase in rate as the object is moved closer to the vehicle. When the object is within 12 in (30 cm) of the bumper, the tone should sound continuously.
   NOTE: If the PAM does not detect the objects as arranged above, refer to Parking Aid .

   Verify that the PAM detects the objects when placed in the specified locations (P1, P2, P3, P4 and P5).