Normal Operation and Fault Conditions
The RCM monitors various inputs and communicates on the CAN. If the values received are out of range or not what should be expected, the RCM sets a DTC.
PPT AR RCM DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B0080:11 | Driver Seatbelt Load Limiter Deployment Control: Circuit Short to Ground | Sets when the RCM detects an incorrect configuration. |
| B0080:12 | Driver Seatbelt Load Limiter Deployment Control: Circuit Short to Battery | Sets when the RCM detects an incorrect configuration. |
| B0080:13 | Driver Seatbelt Load Limiter Deployment Control: Circuit Open | Sets when the RCM detects an incorrect configuration. |
| B0080:1A | Driver Seatbelt Load Limiter Deployment Control: Circuit Resistance Below Threshold | Sets when the RCM detects an incorrect configuration. |
| B0080:2B | Driver Seatbelt Load Limiter Deployment Control: Signal Cross Coupled | Sets when the RCM detects an incorrect configuration. |
| B1193:00 | Crash Event Storage Full and Locked: No Sub Type Information | Sets when the RCM has detected a crash event. |
| B142D:00 | Pyrotechnic End of Life Activation Performed: No Sub Type Information | Sets when the RCM has experienced a pyrotechnic activation event. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | Sets when the RCM detects an incorrect configuration. |
| U2200:00 | Control Module Configuration Memory Corrupt: No Sub Type Information | Sets when the RCM detects an incorrect configuration. |
| U3000:04 | Control Module: System Internal Failure | Sets when the RCM detects an internal failure. |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure | Sets when the RCM detects an internal failure. |
| U3000:49 | Control Module: Internal Electronic Failure | Sets when the RCM detects an internal failure. |