DTC P0351 - Ignition Coil A Primary Control Circuit/Open
P0351 - IGNITION COIL A PRIMARY CONTROL CIRCUIT/OPEN
| Description: | This DTC sets when the PCM does not receive a valid ignition diagnostic monitor (IDM) pulse signal from the ignition module PCM. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | The DTC P0351 only sets for a coil primary circuit failure. A secondary ignition coil or spark plug failure does not set the DTC P0351. The DTC P0301 does not set for a coil primary circuit malfunction. The DTC P0351 may set with or without the DTC P0301, however the DTC P0351 sets first. When this DTC is set, the PCM enters failure mode effects management (FMEM) which shuts down the injector for the associated cylinder in order to protect the catalytic converter. This is normal operation, do not attempt to diagnose the injector with this DTC present. If a primary coil is damaged due to a harness short to ground the PCM will not be damaged. Do not replace the PCM without verifying the coil driver functionality. Use the 12 volt non-powered test lamp to verify VPWR voltage at the ignition coil harness connector. Check the coil driver circuit for open, short to voltage, or short to ground. |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| Fiesta 1.6L TiVCT, KA 1.5L |
GO to PINPOINT TEST JE . | ||
| All others | GO to PINPOINT TEST JF . | ||