LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Transit Connect XL, Van Cargo >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - 2.5L DURATEC (125KW/170PS) >> Removal And Installation >> Engine Mount >> Removal

Engine Mount: Removal

  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
  2. If equipped.

    1. Remove the retainers and the underbody shield reinforcement.
    2. Remove the retainers and the underbody shield.

    GFD304018Courtesy of FORD MOTOR COMPANY
  3. Using a floor jack and wooden block, support the engine. Use the General Equipment: Trolley Jack. Use the General Equipment: Wooden Block
    GFD304070Courtesy of FORD MOTOR COMPANY
  4. Release the degas bottle support tabs, disconnect the coolant hose routing clip and position the degas bottle aside.
    GFD304071Courtesy of FORD MOTOR COMPANY
    1. Remove the engine mount nuts.
    2. Remove the bolts and the engine mount.
GFD304072Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals